OVERHEAD DOOR COMPANY OF BALTIMORE, INC.
3501 Century Avenue,
Baltimore, Maryland 21227

Sales : 410-636-6300
Fax: 410-636-4308
www.ohdbalt.com
502 Churchmans Road,
New Castle, DE 19720

Sales :302-323-4999
Fax :302-323-4930
www.overheaddoordelmar.com
603 Marshall St.,
Milford, DE 19963

Sales :302-424-4400
Fax :302-424-4406
www.overheaddoordelmar.com
PROGRAMMING FOR HOMELINK® SYSTEM

Note: Some vehicles may require the ignition be turned on or the vehicle actually running to program the Homelink® transceiver. To program a rolling code compatible Homelink® system, please follow these steps.

Press and hold the two outside buttons on the Homelink® system until the LED starts to blink, release buttons

Press and hold the desired Homelink® button and the transmit button on your rolling code transmitter at the same time until the Homelink® LED changes from a slow blink to a rapid blink. (Your Homelink® system is now programmed)

Locate the learn code button on your garage door opener. (These are located under the light cover or on the rear panel depending on model)

Press the learn code button on the garage door opener, a red LED will start to blink. (You will have 30 seconds to complete programming)

While the LED on the garage door opener is blinking, return to the vehicle and press the pre-programmed Homelink® button 4 times. (Or until the garage door operates).

If you have problems programming, you might try these steps with the vehicle running.

If you have problems with the Homelink® system please call 1-800-355-3515 or visit the Homelink® system website.

Homelink is a registered trademark of Johnson Controls, Inc.




For Sales Call:
410-636-6300
For Service Call:
410-636-6306


© Copyright 2017 Overhead Door Company of Baltimore, Inc.
Web Site Design by New Blood, Inc.